- Make sure this fits by entering your model number.
- Three compatible replacement cartridges for: 3M Aqua-Pure AP810-2 and AP811-2
- FIlters DO NOT come with end caps as they are not necessary for a proper seal (See description for installation instructions)
- Perfect replacement for the Aqua-Pure AP802 housing. Works well with Pentek DGD-5005-20, DGD-5005
- 5 micron dirt sediment removal rating, Formerly known as KW810-2-Qty3
- Universal 4.5 x 20 inch replacement water filter cartridge
Three KleenWater KW810-2 replacement water filter cartridges compatible with 3M Aqua-Pure AP810-2 and AP811-2. The rigid poly-spun construction effectively removes dirt, rust and sediment with impressive flow rates of up to 40 gallons per minute. Each cartridge contains two distinct micron layers. Larger particles are trapped near the exterior and progressively finer particles towards the filter core. Thus the cartridge has exceptional solids-holding capacity and will perform longer.
Features:
~ Gradient density melt blown polypropylene construction
~ Shrink wrapped for purity
~ Flow rate 40 gpm
~ Recommended cartridge change every 10 nonths or upon substantial pressure reduction
~ Constructed to NSF standards
The industry universal dimension of 4.5 inch x 20 inch makes it compatible with filter housing manufacturers such as GE, Culligan, Cuno, Omni, Kenmore, Whirlpool and Ametek, among others. KleenWater is a trademark of Pavel Water Filtration.
*Occasionally there is concern these filters without the end caps will not be a compatible replacement for the more expensive filters with end caps and gaskets. Please rest assured these will work very well and consider this brief explanation: Creating the upper and lower seal takes some strength and effort. Located on the bottom of the water filter sump and the under side of the filter head are sharp circular rings. These rings cut into the water filter to create the seal. The cartridge is made of polypropylene which is slightly pliable. Therefore when the filter sump is screwed to the filter head the cartridge gets squeezed and the rings create a circular crease on the bottom and top of the cartridge. This is a very simple installation. If you want to soften the cartridge to make it even more simple soak the filter in slightly hot water for 10 minutes prior to installation. This will slightly soften the cartridge.